NX12.0.2 is released and better than ever! July 20, 2018 Jai Scott Blog 0 Comments NX 12.0.2 is released. Unlike previous versions of NX, it does not require a previous NX 12 installation – you can install it as a base installation. https://community.plm.automation.siemens.com/t5/NX-Design-Forum/NX-12-0-2-Maintenance-Release-Announcement/td-p/508119 Tweet Share Share Email Pin It Related Posts DIY Real Life Wrench Mask V1 I created this mask using a typical Arduino Uno & EasyVR Voice Recognition Board. What… Design Visionaries visits PTC’s Silicon Valley Executive Exchange The latest in the digital transformation of IoT & A/R strategy for tomorrow's business. Augmented… Double Helix Begin with a Helix along the Z axis. Make a sketch on the end of… This Post Has 0 Comments Leave a Reply Cancel replyYou must be logged in to post a comment.