NX7.5 The Glass is Half Full September 7, 2011 Landon Ritchie Miscellaneous, Modeling, NX Tutorials, Siemen's PLM Software NX 1 Comment How to make a water line in NX7.5. filled glassglasswaterwater line Tweet Share Share Email Pin It Related Posts Unite by Region The ability to Unite certain portions of the model while trimming out unneeded areas from… NX7.5 Through Curves Created by, soopzable. How to connect a circular tube to a square tube in NX7.5. This… NX6 Stop at Intersection Design Visionaries, www.designviz.com, brings you a helpful tutorial on how to use the "stop at… This Post Has One Comment I’m so glad my glass is now half full! Log in to Reply Leave a Reply Cancel replyYou must be logged in to post a comment.